Switch2 4in1 RGB Charging Dock

Features:
*Designed for charging the left and right JoyCon of Switch 2, and can charge 4 JoyCons at the same time.
*Detachable charging stand design supports separate charging, allowing players to play while charging.
*Low-voltage, over-voltage and over-current protection, safe charging, long-term charging will not damage JoyCons.
*RGB colorful light at the bottom, creates a special desktop light show and an immersive gaming atmosphere.

1. Overcurrent protection
For each charging port, the normal charging current is about 250mA, and the maximum allowed current is 400mA. If it exceeds 400mA, the charging port will be overcurrent protected, and the corresponding blue LED will flash quickly, and charging is not allowed. After the handle is unplugged, the charging function is restored.

2. Low voltage and overvoltage protection
a. When the power input voltage is greater than 5.6v, the charging controller enters the overvoltage protection mode, the blue LED flashes quickly, and charging is not allowed. When the voltage drops below 5.3v, the normal charging function is restored.
b. When the power input voltage is less than 4.2v, the charging controller enters the low voltage protection mode, the blue LED flashes quickly, and charging is not allowed. When the voltage rises to above 4.7v, the normal charging function is restored.

3. Full charge detection
When the charging current of the controller is less than 40mA for 5 seconds, the handle is considered fully charged and the green LED is on. When the current of a fully charged handle is greater than 70mA, the charging function is restored, that is, the green LED turns off and the blue LED turns on.

Parameters:
Input DC voltage: 5V
Input current: 2A
Output voltage: 5V
Charging current: 250mA*4
Rated power: 1.25W*4